Update 1  Update 2  Update 3  Update 4  Update 5  Update 6  Update 7  Update 8  Update 9 Update 10

Aft deck all fared out.

The mid-section decking attached and glued...

And now all fared out.  This job went without a hitch.

The boat flipped on its side so that I can fillet and tape all of the top decking to the sheer.

A picture of the joint that needs to be filleted and then taped.....all sections from nose to stern.

The joint at the transom

One of the joints after it has been  taped/epoxied

The forward section joint was NOT fun.  I had to rig a paint brush to smooth it out stapled to a length of wood to reach it properly.  I pre-wetted the tape to make it a little easier.

And the aft section also finished.  Tomorrow I will turn the boat to its other side to do the same job again.